Lisle Brake Tools
Part #: 10050
Replacement Stones for the 1000 brake Cylinder Hone
Part #: 10490
Replacement Stones for the 10400 Brake Cylinder Hone
Part #: 10550
Set Replacement Stones for 10500
Part #: 10900
5/16" x 3/8" Wrench for Bleeding Air From Brake Cylinders With Bleeder Screws.
Part #: 10950
1/4" x 3/8" Wrench for Bleeding Air >From Brake Cylinders With Bleeder Screws.
Part #: 11260
Double Ended Tool for Removing and Installing Brake Springs.
Part #: 12450
1/4" Hex Bit, Brake Caliper 3/8" Socket
Part #: 12550
Brake Caliper hex Bit Set For Servicing Disc Brakes Three 3/8" square drive sockets with hex bits to remove and replace floating caliper mounting bolts. 3/8" and 8mm hex bits for GM and 1/4" hex bit for Ford.
Part #: 12560
8mm hex bit Brake Caliper 3/8" Socket
Part #: 12570
3/8" hex bit Brake Caliper 3/8" Socket
Part #: 18920
For use with the 18800 Brake Cylinder Retainer Remover
Part #: 19200
Everything needed to quickly bleed brakes with no mess. Plastic bottle collects discharged fluid. Three separate adapters fit the common bleeder screws.
Part #: 24300
Squeeze the handle and the fast acting plunger compresses disc brake pistons in seconds. Makes brake pad replacement an easy job.
Part #: 24400
For Installing Pads on Most Domestic and Import Cars and Light Trucks.
Part #: 25000
For Rotating Pistons Back into the Caliper to Provide Clearance for New Pads.
Part #: 25130
Lisle 1 7/8" Rear Disc Brake Caliper Tool Adapter part number 25130
Part #: 25150
GM Adapter 2 1/8" Included in 25080 Kits
Part #: 25170
GM Adapter 2 1/2" Included in 25080 Kits
Part #: 27740
All Torx bits are made of heat-treated alloy steel. 27740 - 3 pc. set includes T-40, T-45, & T-50 sizes for servicing disc brakes fitting GM and Ford brake caliper Torx bolts.
Part #: 28600
Rotates Piston Back Into the Caliper When Replacing Pads.
Part #: 29150
Includes the following sizes: T-40, T-45, T-47, T-50, 1/4", 3/8", 7mm, 8mm and 10mm. All bits are 3/8" square drive
Part #: 33900
This 7mm hex bit is used for some AMC, Audi, Ford, Jeep, Lincoln and Volkswagen applications. Use with 3/8" drive
Part #: 33920
Hex bits remove and install floating caliper mounting bolts. 10mm hex is used for some Chevrolet and GMC van and truck applications. Use with 3/8" drive.
Part #: 44000
For 3/16", 1/4", 5/16" and 3/8" O.D. tubing. Not recommended for 3/8" steel.
Part #: 45100
This tool removes and installs import brake return springs
Part #: 46750
A spring tool for removing and replacing brake return springs that are set over a post
Part #: 47400
Fits Both Large and Small Washers.
Part #: 50700
Insert tool through slot in backing plate. Different angle at each end adapts to various makes and models.