Engine Kits

Reman Crank Kit 1986-1999 262cid, 4.3L, V6, Vin Code Z
Click On Image To Enlarge

Reman Crank Kit 1986-1999 262cid, 4.3L, V6, Vin Code Z

Part #: 18060
List Price: $324.48
Our Price: $187.20
You Save: $137.28

Core Price: $77.63
Availability: In Stock

1986-1999 262cid, 4.3L, V6, Vin Code Z, with casting number 480, 460, 865, 5480, 5865, 8640, 10055480, 10105865, 14088640.

This heavy crankshaft is used in all engines without balance shaft and in all Vin Code Z engines with heavy pistons and pin assemblies (745 grams). This crankshaft has two keyways.

You must match your casting number with the casting numbers listed, before you order your Crankshaft Supply, Crankshaft part number 18060.

Crankshaft Supply GM 6 Cylinder Re-manufactured Crank Kits

Crankshaft Supply Re-manufactured Stock Cranks. These Crankshaft Supply GM 6 Cylinder Crankshafts are thermal cleaned, steel shot blasted, bolt holes and keyways inspected, centerline checked, straightened and magnafluxed. Necks, flanges and badly worn journals are restored, bearing journal surfaces machined, polished, oil holes chamfered, thoroughly cleaned, with filleted radius to maintain OE specs. Bearings are included with Crankshaft unless noted.

 Core Return Policy - Cores returned for credit need to be sent at shippers expense in rebuild-able condition. Return cores "rust-free". We recommend you return it in the package sent to you. To insure prompt credit for your core, enclose a clear copy of your original invoice.

Crankshaft Supply has been repairing and machining Crankshafts, Rods, and more for over 50 years. Crankshaft Supply are the specialists in Crankshaft repair. . Crankshaft Supply is proud of their dedicated staff, and their dedication to your satisfaction

Crankshaft Supply Chevy Crankshaft Kits Are:

  • Thermal Cleaned 
  • Steel shot blasted 
  • Bolt holes and keyways inspected 
  • Worn journals are restored 
  • bearing journal surfaces are machined, polished 
  • Oil holes chamfered and deburred 
  • oil line passages clean and rust inhibitor applied 
  • Crankshafts are packed and covered with two-mil poly film and encapsulated with sprayed foam 
  • Main and Rod Bearings are included,  unless noted

The poly film is a Rust inhibitor therefor you must wash the entire crank with soap and water at least 6 hours before you install it ( we recommend that you rinse your crank at least three times to remove all traces of soap)