Engine Kits

TYPE B 6"X 12"
Click On Image To Enlarge

TYPE B 6"X 12"



Part #: TYPEB612
List Price: $23.98
Our Price: $11.99
You Save: $11.99

Availability: In Stock

Free Ground Domestic Shipping On This Item
Free Ground Domestic Shipping To 48 Contigous States

6" x 12" piece of Tear-Aid Type B

Type B:  works for Vinyl and Vinyl-Coated Materials.

Each TEAR-AID® repair patch is made from an exceptionally tough, matte finish, abrasion resistant, elastomer that resists puncture and tearing.  It is combined with an aggressive adhesive formulated for high bond strength to a variety of surfaces such as canvas, leather, rubber, nylon, most plastics, paints, aluminum, stainless steel, fiberglass, polyurethane, polyethylene, polypropylene, vinyl and vinyl coated.  TEAR-AID®Type A and TEAR-AID® Type B provide a simple and easy method of patching holes and tears, as well as an excellent protective film solution.


GENERAL TEARS AND HOLES

 

For best results apply to a clean, dry surface. Clean the surface to be repaired with an alcohol prep pad, or a 50/50 mixture of rubbing (isopropyl) alcohol and water.

 

Surface temperature of the materials to be repaired should be 50 F or warmer. Do not put repaired material into a washer or dryer.

 

Before proceeding make sure surface is dry, and you have the correct patch type for the kind of material you are repairing.  This is for VINYL repair only!

 

STEP 1 Cut patch to size with scissors allowing for the patch size to extend 1 inch beyond all edges of the tear. If using more than one patch, allow for patch sizes to overlap at least 1 inch. Trim square corners into rounded corners.

 

STEP 2.  Peel - Carefully peel back ½ inch of paper liner. Tearing the paper liner while stretching the edge of the patch will help to separate the liner from the patch - especially when the patch has been cut into smaller sizes.

 

STEP 3.  Stick - Position and anchor exposed ½ inch edge – allowing the patch to extend 1 inch beyond all edges of the tear. Slowly peel back the liner while carefully applying the patch over the tear – take care to avoid air bubbles. Rub all edges to seal. Rub entire patch aggressively. Follow Steps 1-3 on the back side of the repair if you have access to the back side. Repair is complete.

 


TEAR-AID® Repair Patches fix many different products in almost ALL industries:  Fishing, Hunting, Camping, RV, Sporting Goods, Inflatables, Wind and Kite Surfing, Kayaks, Marine, Boating, Seat, Military, Medical, Awnings, Tents, Pool Supply, Waterparks, Surf and Dive Shops, Police and Fire, Beach Resorts, Hardware Stores, and Auto Parts Stores.

Each TEAR-AID® repair patch is made from an exceptionally tough, matte finish, abrasion resistant, elastomer that resists puncture and tearing. It is combined with an aggressive adhesive formulated for high bond strength to a variety of surfaces such as canvas, leather, rubber, nylon, most plastics, paints, aluminum, stainless steel, fiberglass, polyurethane, polyethylene, polypropylene, vinyl and vinyl coated.  TEAR-AID® Type A and TEAR-AID® Type B provide a simple and easy method of patching holes and tears, as well as an excellent protective film solution.